Cnc flame cutter affects some elements of life. For the cnc flame cutter, the life source affects the pump source and the crystal inside, which is actually the life of the lamp. Generally speaking, the life of a standard lamp, the life of the crystal. When the energy is reduced, the processing performance of the cnc flame cutter will be greatly reduced, so the only solution is to replace the pump source and crystal.
When the cnc flame cutter cuts the material, the working surface releases a lot of gas and spatter, which will cause damage to the lens. When the contaminant falls on the lens surface of the cnc flame cutter, it will absorb energy from the laser beam, resulting in a thermal lensing effect. If the lens of the cnc flame cutter has not formed thermal stress, the operator can disassemble and clean the cnc flame cutter.
The power of the cnc flame cutter suddenly drops, and it is possible that the glass tube is broken. In the inspection of the cnc flame cutter, there is a mark of watermark on the wall of the broken glass tube. It can increase the power of the air conditioner and the air dryer to reduce the air humidity; in the case of high humidity, the glass of the cnc flame cutter may also be broken. No dirt and residual traces remain on the mirror surface; dry with dry air, if necessary, roll the lens paper wet with a few drops of acetone into a rod and gently scrub the lens surface of the cnc flame cutter to remove heavy stains.
