What to do when an error in the cutting of the CNC cutter?
If we have some serious and very many effects in the process of using CNC cutters, so we hope that we can effectively avoid these errors in the process of use, but what should be done?
The graphical contours of CNC cutters are sometimes cut constantly. Technical engineers believe that the main reason for the continuous cutting of the graphic contours of CNC cutters is that the operating system software of CNC cutters does not have the function of cumulative error correction. The specific detection methods are given as follows:
The CNC code (NC file) can be converted into an AutoCAD graphic, and then under AutoCAD, check that the end point at the leadout of the closed profile is fully matched, and if it is fully re-matched (contour closed), there is a cumulative error correction technique, which is not available if it is not closed.
Some CNC cutter operating system software in order to cover up the accumulated error caused by the cut-in point of misalization, blindly raise the code's scale of the scale, which is actually ineffective. Code accuracy must be consistent with pulse equivalent, if the code accuracy is higher than pulse equivalent accuracy, it will cause greater misality, resulting in the continuous cutting of graphic contours.
General CNC cutting machine in the process of operation of cutting errors can be handled and resolved according to the above method, there will not be much impact. Quality service, quality first.
